How to prepare a file for printing on ready-made cardboard boxes?
Project sizes
The project should be prepared according to the selected template available in the calculator after choosing a specific box design/size.
Die-cut templates are available in the D&D database and do not need to be attached to the submitted files.
Do not change the proportions, dimensions, or layout of the provided template.
Job preparation
The finished design should be prepared as a multi-page PDF file (single- or double-sided print design).
All essential project elements, such as texts, logos, and important graphic elements, should be placed only within the designated safe area, maintaining a distance from the crease lines and the packaging edge,
The print area depends on the box construction and is marked on the die-cut template,
Backgrounds and graphics reaching the edge should be prepared with a 2 mm bleed,
The minimum distance of important elements from the creasing line and edge should be 5 mm.
Design template
The shape of the cutting line in the template is for reference only. There may be minor differences in the shape of flaps, locks, glue strips, and other technological elements between the template and the applied die. The dimensions of the finished box, the location of the crease lines, and the print areas remain in accordance with the product specification.
Note
Due to the specifics of corrugated cardboard and the production tolerances of ready-made die-cuts, slight shifts of the print relative to the crease lines and packaging edges may occur. For this reason, it is not recommended to design elements that require perfect alignment with creases, folds, or box edges.
Individual boxes in a batch may slightly differ in dimensions and die-cut arrangement, which is a natural feature of corrugated cardboard packaging production. This may cause minor differences in the print position between individual copies.
Color scheme
The project should be prepared in the CMYK color space.
Do not leave elements in the RGB space, as their conversion to CMYK may cause shade changes.
The total CMYK components in the project should not exceed 200%, unless a test has previously been performed on the target material.
Excessive ink saturation may cause improper drying, ink spreading, and loss of edge sharpness in prints or small elements. Therefore, large color areas, such as tints and solids, should be avoided.
If you want intense, vivid colors, build them from one or two CMYK components with the highest possible saturation. Adding a third component or black usually reduces color intensity on absorbent substrates.
For example, an intense red is best defined as:
C: 0% / M: 100% / Y: 100% / K: 0%
Black color
Black for texts, thin elements, and other black objects should be prepared as 100% K only, without additional components
C: 0% / M: 0% / Y: 0% / K: 100%
Raster graphics and photos
Raster graphics, photos, and bitmaps should have a resolution of at least 300 dpi.
Enlarging graphics with too low a resolution does not improve their quality and may cause visible pixelation or loss of sharpness in print.
Texts and vector elements
Logos, texts, QR codes, and barcodes are best prepared as vector elements.
All texts should be converted to curves.
QR codes and barcodes
Codes should be black 100% K on a light background. QR requires a clear margin, the so-called quiet zone, of at least 4 modules on each side.
Color reproduction and substrate influence
Printing is done without the use of white ink. This is especially important in the case of grey (brown) cartons, as the substrate color affects the final appearance of the print. The monitor emits light, while the carton reflects it. Therefore, even a correctly prepared design may look slightly different on the screen than on the finished bag.
For projects where color is crucial, the best way to assess the effect is to order a prototype for 1 PLN. https://www.printnet.pl/pudelka-tekturowe-gotowe-lista
