Sizes | Final Trim Size | Web-fed inkjet printing on HP Latex 360, Mimaki JV300, Canon Colorado 1650.
Max. printing area: according to specification.
Larger prints are done in sheets with 15mm tabs.
Grouping several smaller jobs into one file and submitting as a single larger order is possible. | Bleed | Prepare your artwork with no bleed (for printing in pieces we do it for you) or, in case of jobs to be glued to rigid media, with 5mm bleed (i.e. extend each edge of the page by 5mm).
Do not place trim marks. Instead of this only frame your job.
If you put several smaller jobs in single file, each of them must have a separate frame. | Job Scale |
1:1
|
|
Graphics | Colour Model | Prepare your artwork in CMYK model (except for artwork with additional colour). If your artwork contains halftone images (textures, photos), convert it also to CMYK.
Using different colour spaces or colour models in one document (e.g. CMYK and RGB) leads to incorrect colour rendering and is not covered by warranty. | Colour Screen Tints | If your artwork consists of large areas in single colour, we recommend to add some noise or slight texture to those areas in order to avoid visual bands. | Rich Black | To achieve a full, dark black, use a black color composed of 33%C 33%M 33%Y 100%K. For printing on backlit materials, use 60%C 55%M 50%Y 100%K. | Tone Gradation | Do not set your tonal range for values smaller than 5%. To avoid visual bands, add some noise to your gradation. | Optimum Resolution | up to 2m²: 100-200 dpi
2-5m²: 50-100 dpi
5-20m²: 20-60 dpi
Don't increase resolution through resampling. | Utility location | Where one project contains multiple pieces, add a thin-line frame around each piece, and the distance between the pieces must be greater than 5mm. In the calculator’s window „Additional cutting for jobs pieces” enter the number of pieces. |
|
Saving to File | File Formats | Preferred: PDF
Accepted: CDR, TIFF, JPG (not recommended).
Please note: In case of INDESIGN software, we accept only PostScript files. Otherwise, please use the Comment section to inform us: "Attention: InDesign file. Convert to PS, please". TIF, JPG
Accepted: CDR(ver.9.0)
| Additional Information | If you save your artwork as CDR file, please rememeber to:
- convert all texts to curves / paths,
w przypadku skomplikowanych projektów zawierających wiele warstw, nachodzące na siebie grafiki, cienie, przezroczystości itp. należy, na ile jest to możliwe, spłaszczyć do jednego obrazu tła, zachowując w postaci wektorowej jedynie teksty, loga, linie i inne istotne elementy projektu.
- supply your artwork with a mock-up (200-300kB JPG file) so we can check correctness of a delivered file.
|
|
Additional Information | Preparation for Plotter Cutting | See the detailed instruction how to prepare your artwork for plotter cutting:
:
See here >> | Additional Information | If you do not provide us with a mock-up of your artwork, we will print your order however D&D Ltd. does not take responsibility for its incorrect interpretation.
Please note: During cutting jobs printed on PVC boards some slight For that reason please avoid putting in your graphics dark and saturated colours running right off the edge of your design. |
|
|
|
|
|